Velux ZMT 300 Instalační příručka stáhnout pdf

ZMT 300

Instructions For

The Motorized Control Rod

WARNING: When using electric tools, basic safety precautions

should always be followed to reduce the risk of fire, electric shock,

and personal injury:

1) Do not store or carry battery so that metal objects can contact

exposed metal end. For example, do not place battery in aprons,

pockets, tool boxes, drawers, etc. with loose nails, screws, keys, etc.

Battery could short circuit causing fire, burns or damage to battery.

2) Never attempt to open the battery for any reason. If the

housing of the battery breaks or cracks, discontinue use

immediately and do not recharge.

3) Do not incinerate the battery; it can explode in a fire. Leakage

of liquid from batteries can occur if damaged. If the outer seal

broken and this leakage gets on your skin:

a. Wash quickly with soap and water.

b. Neutralize with a mild acid such as lemon juice or vinegar.

c. If the battery liquid gets in your eyes, flush them with

clean water for a minimum of 10 minutes and seek

immediate attention.

MEDICAL NOTE: The liquid is a 25-35% solution of potassium hydroxide.

Charge batteries with VersaPak battery charger. Charger

recharges batteries in approximately three hours. Remove

battery charger from the outlet after charging.

5) Do not use charger in wet or damp conditions. It is intended

for indoor use only. Do not use near sinks, tubs, etc. Do not

immerse in water.

6) Do not use charger for any uses other than charging

VersaPak Batteries. Other batteries may explode.

7) Do not operate charger with damaged cord or plug

. Have

them replaced immediately.

8) Do not operate charger if it has received a sharp blow, been

dropped, or otherwise damaged in any way.

9) Do not disassemble charger. Incorrect reassembly may result

in electric shock or fire. There are no consumer serviceable

parts inside.

10) For best results, do not charge batteries when they or the air

temperature is below 40°F or above 105°F.

11) The charger is designed to operate on standard household

electrical power (120 volts AC only). Do not attempt to use it

on any other voltage.

12)

Unplug charger when not in use.

13) Do not abuse charger cord. To reduce the risk of damage to

electric plug and cord, never carry charger by cord or roughly

pull it to disconnect from receptacle. Keep charger cord from

heat, oil, and sharp edges.

IMPORTANT SAFETY INSTRUCTIONS

1 2

Shrnutí obsahu

Strany 1 - IMPORTANT SAFETY INSTRUCTIONS

ZMT 300Instructions For The Motorized Control RodWARNING: When using electric tools, basic safety precautionsshould always be followed to reduce the r

Strany 2 - The RBRC Seal

Removing and Installing BatteryNOTE: VERSAPAK‰ Batteries are not fully charged at the factory.To install the battery into the ZMT 300, simply slide i

Komentáře k této Příručce

Žádné komentáře

Velux ZMT 300 Instalační příručka

Procházejte online nebo si stáhněte Instalační příručka pro Nabíječky baterií Velux ZMT 300. VELUX ZMT 300 Installation Guide Uživatelská příručka

Shrnutí obsahu

Komentáře k této Příručce